12.3.2 Removing The Filter Mesh Assemblies
Both the coffee brewer and tea brewer contain fine screen mesh assemblies
which ensure coffee and tea vends are produced to the highest standards. To
remove the mesh assemblies, proceed as follows:
1. Remove the brewer unit from the machine as previously described and
place on a flat surface. Lift the latch bar and remove the brewer
chambers/wipe arms assembly.
2. Removing the coffee filter mesh: Using the coffee filter extractor tool,
part no. ME10385000, insert the tool into the output spout of the coffee
brewer chamber with the tip pointing upwards.
3. With the tool to the rear of the chamber, gently push up on the rear of
the filter assembly to unseat it. Remove the filter assembly from the
brewer.
4. Removing the tea filter mesh: Using a small flat bladed screwdriver or
similar, insert the tool up through the tea outlet and carefully push the
filter assembly up and out of its location.
5. If necessary, soak the filter mesh assemblies in a correctly diluted cleaning
solution for a maximum of 30 minutes. Rinse the filters with clean water
before refitting to the brewer unit.
6. Replacement filters are available from the manufacturer.
Coffee Filter - Part No. PL07155000
Tea Filter - Part No. ME10380000
12.3.3 Refitting The Filter Mesh Assemblies
The following description applies to both the coffee and tea filter assemblies.
1. Ensuring that the gauze screen is to the top, align the filter assembly with
its locating position above the brewer chamber. Ensure that the locating lip
on the filter assembly lines up with its corresponding slot in the chamber.
2. Push down on the filter assembly to secure it in its locating position.
Technical Manual
123
To Next Page
Loading...
Need help?
General
