2.4 Commissioning Procedure
The following procedure must be carried out by a trained installation engineer
before the machine can be used for the first time.
1. Ensure that the electrical and water services to the machine are connected
correctly and turned on. Ensure that the waste tray is fitted correctly to
the machine. Open the front door of the machine and swing the cup turret
assembly out of the machine.
2. All Machines: Rotate soluble ingredient canister outlets to upright
position and remove the canisters - DO NOT place ingredient canisters
on the floor. Remove the canister lids.
Fill the canisters with the correct ingredients, re-fit the lids and re-fit
canisters into machine ensuring that they are returned to their correct
positions. Rotate the canister outlets to their correct operating positions.
Freshbrew Machines: Fill freshbrew ingredient canisters with freshbrew
tea and coffee ingredient and refit to machine.
B2C Machines: Release the clips securing
the bean container cover as shown in the
photograph. Carefully lift the cover from the
container. DO NOT place the cover on the
floor.
Fill the container with fresh coffee beans. The
container has a capacity of approximately 1.8
kgs. Refit the cover ensuring that the clips
are located correctly.
N.B. To maintain optimum drink quality, Crane Merchandising Systems
recommend that the bean container is replenished on a daily basis.
3. Fill the cup turret tubes with the correct size
cups for the type of cup catcher fitted to the
machine. Allow the cups to drop into the
tubes directly from the packaging. DO NOT
TOUCH THE CUPS WITH YOUR HANDS.
Important! Do not fill the tube directly
above the cup dispense position. Allow the
cup turret motor to rotate a full tube to the
cup dispense position. Rotating the cup turret
by hand will damage the mechanism.
Note: If paper cups are being loaded, each pack of cups must first be
inspected for damage to the cup rims. Damaged cups must not be used.
Technical Manual
15
To Next Page
Loading...
Need help?
General
