5
Technical Manual
Important Safeguards
When installing or servicing the Genesis, always have this manual available for quick
and easy reference and always follow these basic safety precautions:
1. Ensure that the machine is situated on a strong horizontal surface (see
Specifications Table page 6), at a convenient height and in a position where
it is not likely to be knocked off.
2. The mains lead should never trail from the machine and should always be
kept away from hot surfaces and sharp edges.
3. Allow the machine to cool before handling or moving.
4. Ensure that the mains electricity supply is isolated before removing any of
the protective panels or undertaking any major servicing. Working on live
equipment should only be undertaken when there is no practical
alternative.
5. Important! Instant and freshbrew machines: Servicing the heater tank.
Water in the tank can reach a temperature of approximately 99º C. Water
at this temperature can cause severe burns! B2C machines are fitted with
a pressurised water system. Under no circumstances should this be
dismantled, other than by a fully trained engineer.
6. Never immerse the machine in water, or any other liquid. This machine
must not be installed in an area where a water jet may be used. Never use
a water jet to clean this machine.
7. In normal operating conditions the machine should not freeze-up. In the
unlikely event of the machine freezing, turn off the mains water supply,
disconnect the machine from the mains electricity supply and contact
Crane Merchandising Systems for assistance.
8. Ensure that you are conversant with the ‘Health and Safety at Work and
Electricity at Work Regulations 1989’.
ALWAYS DISCONNECT THE MACHINE FROM THE MAINS
ELECTRICITY SUPPLY BEFORE CLEANING AND SERVICING.
This machine is for indoor use only and because it is a beverage machine, should be
sited in a clean, hygienic area.
It is the policy of Crane Merchandising Systems (CMS) to continue developing its
range of beverage equipment. The information presented within this document is for
information only and may be changed without prior notice. Crane Merchandising
Systems accepts no responsibility for damage caused to the equipment through
misinterpretation or misuse of the information contained in this manual.
To Next Page
Loading...
Need help?
General
