b. Press and release the Flush (button 3). The flush sequence begins.
c. Empty the waste water container when complete.
5.4 Button 4 - Brewer Clean (Freshbrew Machines)
The brewer clean button enables the brewer to be cleaned independently. In order
to guarantee the highest standards of cleanliness, the boiler fill valve is disabled,
ensuring that the water used is delivered at the optimum temperature to kill any
micro-organisms.
1. The brewer unit is filled with hot water and then operated through four
complete brew cycles.
2. During the cleaning cycle the LCD will
display the message as shown.
3. Once the cleaning cycle is complete, the
boiler refills and when the water is at
the correct temperature, the machine
returns to standby mode, ready to vend.
5.5 Button 5 - View Counters
This button enables the operator to access the Data Recall Menu. Entry into this
menu allows the operator to view Non-Resettable and Resettable Sales Data, view
data relating to Timed Events and Identification Numbers of installed components
and (if feature enabled) view SureVend™ assisted vend information. The
Resettable
Sales Data and SureVend™ Data menus contain an extra sub-menu which allows the
operator to delete the current data from the machines memory. Full details relating
to these menus and contents see pages 24-26.
5.6 Button 6 - Test Vend
This button enables the operator to vend a drink from the machine to ensure
correct operation after cleaning or maintenance.
1. When the button is pressed and
released the LCD will display the screen
as shown opposite. The operator then
presses a drink selection button
followed by the START button to begin
the vend sequence.
2. Ensure that the selection is correct, has not under/overfilled the cup and
most importantly, tastes good.
3. Press the X (Exit) key on the drink selection keypad to exit from the Test
menu and return to stand-by mode.
Technical Manual
71
To Next Page
Loading...
Need help?
General
