8
ACITY (AUTO CITY) SPEED: Automatically adjusts sensitivity to
your speed. E.g. When set to 30 50, the
detector will not notify you of any signal
at speeds of less than 30 km/h, at speeds
of 30-50 km/h, the detector will notify
you according to the ACITY setting, and
when driving at speeds over 50 km/h,
the detector will automatically notify you
with maximum sensitivity. When driving
below the set speed, the detector will not
warn of radars.
MIN SPEED: OFF/10-130KM/H - Sets the minimum
speed at which the detector starts to
alert on radars. E.g. when set to 20KM/H,
the detector will only start to warn when
this speed is exceeded.
K BAND: ON/OFF
K FILTER: NORMAL/HIGH/OFF
KA BAND: NARROW – Narrowed Ka band for more
specic band setup and fewer
false alerts.
WIDE – enables detection
of the whole Ka band.
OFF – disables Ka band detection.
KA BAND 34.0: ON/OFF
KA BAND 34.3: ON/OFF
KA BAND 34.7: ON/OFF
KA BAND 35.5: ON/OFF
KA FILTER: NORMAL/HIGH/OFF
LASER DETECTION: ON/OFF
MR CT: WIDE/NARROW/OFF
MR CD: WIDE/NARROW/OFF
GATSO RT3: ON/OFF
GATSO RT4: ON/OFF
MR FILTER: LOW/HIGH/OFF - This function lters out
false alerts of cars that use a blind-spot
assistant or adaptive cruise control.
When the MR Filter function is active,
detector sensitivity to MR CT/CD radars is
slightly reduced.
New Firmware updates add detections of new types of radars, all
supported radars, recommended settings and more information can be
found at www.genevo.com/en/radars_en.
To Next Page
Loading...
