GENEVO
G
A
Genevo PRO CONTROL UNIT
The control Unit is usually placed in a fuse box, space above pedals, using stripping tape to wires in
your car, or using double-sided duck tape. Connecting individual components is obvious thanks to
writing on the control box. All can be easily done thanks to plug-in connectors. When connecting
individual accessories please mind the plug you are trying to connect the cables into, as they must
be connected to a correct plug, in case it isn't so the GENEVO PRO might not work properly or be
permanently damaged. Also be mindful of placing the control unit so that the speaker on top of it is
placed facing in free space.
B DISPLAY
The display is usually placed in vehicle cabin on your consideration using the double-sided sticky
tapes, or magnetic tape. We recommend placing the display in an easily accessible area.
C GPS ANTENNA
Place the GPS antenna using double-sided duck tape to a place where the antenna can see the sky.
Ideally on the dashboard of your car. If you are placing it under the dashboard, make sure that the
antenna is not covered by any metal objects. you can check the antennas functionality on the
display. If the GPS icon glows constantly, it means it works as intended, in case it's blinking it
means that it can not find a GPS signal. The first time it can take 1-5 minutes for the GPS to
connect.
Radar Detector Genevo PRO 11
To Next Page
Loading...
