GENEVO
G
G LASER SENSORS
Laser sensors can be mounted on the front of the vehicle in the front grill, above the bumper or in
the rear of the vehicle. Be extra careful to not damage the cable, sensor or connector during
installation, as it will terminate your warranty. To ensure better looks of your vehicle we
recommend to use plexiglass „Perspex” to hide the sensors. For more information about the glass
please contact your distributor.
To drive the cables to the fuse box, please use the original cable pass. In case there is not enough
space there you will need to drill an extra hole for the connector and the cable. Please be extra
careful again to not damage cables or other car installation. After you finish the cable installation,
you should seal the gap using silicon or other fillings to prevent water and humidity entering the
vehicle. Check the cable if its long enough to reach the desired destination. When you have
connected together with a cable from the sensor (1m long) with the control box cable (4m long)
make sure to use waterproofing duck tape. You can use hot air or lighter to make the seal even
tighter. Place the sensors so that they have a clear view to the front or the rear using the included
holders and double sided duck tape. If necessary, you can bend the holder into required position.
Make sure that the sensor is held firmly and can withstand vibrations caused by cruising and is still
in horizontal front/rear facing position.
Radar Detector Genevo PRO 14
To Next Page
Loading...
