Genie 4560 - Important Safety Instructions; Key Safety Guidelines

RECOMMENDED TOOLS
A
B
Tools(Figure 8):
Additional tools to make installation easier:
Slotted and phillips screw-driver bits
Studfinder
Sheet-metalcutting snips
REMOVE E×mSTmNG GARAGE
DOOR LOCKS
Checkthat the garage door locks,rope,and T-Handlesare
removed from the garage door before starting the installation.
A If your garage does not havea separateentry door, it is
highly recommended to install a GenieEmergencyReleaseKit
(GER-2).EmergencyReleaseKit letsyou open the garage door
from outside if there is aPower failure. (Pleasesee Accessories
Order Form on page 14.)
Before going further, get any items and tools if needed
for your installation
_7 Garagedoorframereinforcementbrackets,screws,bracing
orreinforcementkits(dealer)
_7 LagScrews(1-1/4")for awood doorlessthan 2"thick(store)
_7 Electricaloutlet and/orwiring (suppliedbyalicensedelectrician)
_7 Sufficientangleironorstrappingfor hangingPowerHead(store)
_7 60Watt light bulbs(Roughservicebulbsrecommended)(store)
_7 GER-2EmergencyReleaseKitfor entryduringpowerfailure(store)
_7 Woodfor header,ceiling,and/ordoorbraces(store)
_7 MasonryfastenersforSafe-T-Beam®Bracketinstallation(store)
_7 Safe-T-Beam®BracketExtensions(dealer)
_7 Masonrydrill bit (store)
_7 ExtensionKit (for8'GarageDoors)(deater)
Go to Assembmy and InstallationPosterforfull
Installation instructions.
EUectric
DdB
I/t6" 5/32" Tape MeasurerS:3
DriH Bit DriH Bit
6' or 7'
Step Ladde_
Wire Phillips Screwdriver
Stripper
AdjustaMe Wrench FUat BUade Screwdriver
* /
Hammer Safety, GUasses r/l_ _-_
PenciU
1/4" 5/16" 3/8" 7/16" I/2" 9/16"
Sockets
Hack Saw Wrench
Carpenter's LeveU
Figure 8 Recommended Tools
SAFETY INSTRUCTIONS
WARNING:
SEVERE INJURY OR DEATH
I READANDFOLLOWALLINSTRUCTIONS.
2
4 NEVERGOUNDERASTOPPED.PARTIALLYOPENDOOR
7 KEEPGARAGEDOORSPROPERLYBALANCED.SeeOwner"s
MOTES, REM{NDERS
For Help, call 1-800-35-GENmEot visit www.geniecompany.com