CAL
RUN
SET
CLEAR
SCROLL
CAL
RUN
6.3
1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2) Press Scroll until display reads “BRAKING RATE >#.” where # is the
deceleration rate, ranging from 0 to 9. 0=max. braking. 9=Min.
Figure 6.
3) Press SET/CLEAR key to toggle between 0 and 9—one digit at a time.
4) Pick a value and operate the door. Adjust as necessary.
5) Press a SCROLL key to shift to a new function and lock in the setting.
6) Press CAL/RUN to return to run mode.
Setting Braking Rate (optional)
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
BRAKING RATE 0
Figure 6
www.geniecompany.com 06-12
Standard Duty Operator
GCL-T
To Next Page
Loading...
