Genie GCL-T - Default Chapter; Table of Contents

TOC
www.geniecompany.com 06-12
Table of Contents
Section 1 How to use this manual ................................................. 1.1
Section 2 Safety Information & Instructions ................................ 2.1
Section 3 Critical Installation Information ............................ 3.1-3.2
Section 4 Installation ................................................................4.1-4.9
Drawbar Assembly ...............................................................4.1-4.6
Attach Operator ...........................................................................4.7
Connection to the Door ............................................................4.8
Clutch Adjustment .......................................................................4.9
Section 5 Wiring ........................................................................5.1-5.9
Line Voltage Wiring ....................................................................5.1
Low Voltage Control Wiring ....................................................5.2
External Wire Diagram ...............................................................5.3
Wall Control ................................................................................... 5.4
Interlock Switches .......................................................................5.5
Photocell Wiring ..........................................................................5.6
Sensing Edge Wiring ..................................................................5.7
External Radio Installation .......................................................5.8
Connecting Motor/Safety Information ...............................5.9
Section 6 Operator Setup Procedures .....................................6.1-6.9
Setting Close Direction ...............................................................6.2
Setting Braking Rate ................................................................... 6.3
Setting Travel Limits ...................................................................6.4
......................................................................
Setting Limit Overrun ..................................................................6.5
Monitored Reversing Devices ..................................................6.6
Setting Open & Close Modes ...................................................6.7
(Optional) Transmitter Programming....................................6.8
Setting Mid-Stop Limit ................................................................6.9
Resetting the MRT 6.10
Section 7 Special Operational Features ..................................7.1-7.2
Operator Cycle Count ................................................................7.1
GDO & Display Firmware .......................................................... 7.1
Operator Type............................................................................... 7.2
Section 8 Troubleshooting ......................................................8.1-8.5
Display Operation .......................................................................8.1
Error Codes .............................................................................8.1-8.2
Run Codes ...............................................................................8.2-8.3
Troubleshooting Example using Codes ..............................
8.3
LED Indicators ............................................................................... 8.4
Safe-T-Beam® Troubleshooting Chart ................................. 8.5
Section 9 Service & Maintenance ................................................... 9.1
Preventive Maintenance Schedule .........................................9.1
Section 10 Appendixes ........................................................ 10.1-10.11
Appendix A ........................................................................10.1-10.9
Basic Operator Parts ...............................................................10.1
Basic Shafts Parts ......................................................................10.3
Basic Rail Parts ......................................................................10.4
Basic Carriage/Door Arms Parts.......................................10.5
Basic Electric Box Parts ......................................................10.6
Electric Box Layout ..............................................................10.7
Appendix B ..................................................................................10.8
Screw Terminal Assignments ..........................................10.8
Appendix C ...................................................................... 10.9-10.11
Run Codes ...............................................................................10.9
Error Codes ...............................................................10.10-10.11
Section 11 Warranty .......................................................................11.1
Standard Duty Operator
GCL-T