S-40 • S-45 • S-40 TRAX • S-45 TRAX Part No. 826364
October 2014
TABLE OF CONTENTS
x
Section 3 Scheduled Maintenance Procedures, continued
B-14 Test the Drive Brakes ................................................................................ 3 - 27
B-15 Test the Drive Speed - Stowed Position ..................................................... 3 - 28
B-16 Test the Drive Speed - Raised or Extended Position .................................. 3 - 29
B-17 Test the Alarm Package (if equipped) and the Descent Alarm .................... 3 - 30
B-18 Perform Hydraulic Oil Analysis ................................................................... 3 - 31
B-19 Inspect the Fuel and Hydraulic Tank Cap Venting System ......................... 3 - 32
B-20 Check the Track Tension and Fastener Torque - TRAX Option .................. 3 - 33
B-21 Test the Emergency Power System............................................................ 3 - 34
B-22 Perform Engine Maintenance - Ford Models ............................................... 3 - 35
Checklist C Procedures
C-1 Grease the Platform Overload Mechanism (if equipped) ............................. 3 - 36
C-2 Test the Platform Overload Mechanism (if equipped) ................................. 3 - 36
C-3 Replace the Engine Air Filter - All Models .................................................. 3 - 40
C-4 Perform Engine Maintenance - Perkins Models .......................................... 3 - 41
C-5 Perform Engine Maintenance - Perkins Models .......................................... 3 - 41
C-6 Perform Engine Maintenance - Deutz Models ............................................. 3 - 42
C-7 Check and Adjust the Engine RPM - Perkins 404D
and Deutz 2011 Models .............................................................................. 3 - 42
C-8 Perform Engine Maintenance Ford Models ................................................. 3 - 44
Checklist D Procedures
D-1 Check the Boom Wear Pads ...................................................................... 3 - 46
D-2 Check the Turntable Rotation Bearing Bolts ............................................... 3 - 47
D-3 Inspect for Turntable Bearing Wear ............................................................ 3 - 48
D-4 Replace the Drive Hub Oil .......................................................................... 3 - 50
D-5 Check the Free-wheel Configuration ........................................................... 3 - 50
D-6 Replace the Hydraulic Filters ...................................................................... 3 - 52
D-7 Perform Engine Maintenance - Perkins Models .......................................... 3 - 53
D-8 Perform Engine Maintenance - Deutz Models ............................................. 3 - 54
D-9 Perform Engine Maintenance - Deutz Models ............................................. 3 - 54
Section 1 • Table of Contents
To Next Page
Loading...
Need help?
General
