Genius BRAIN 06 24V - Page 11

9
ENGLISH
WARNINGS
• Important! For the safety of people, it is important that all the instructions be carefully observed.
• Incorrect installation or incorrect use of the product could cause serious harm to people.
• Carefully read the instructions before beginning to install the product and keep them for future
reference.
• The symbol
indicates notes that are important for the safety of persons and for the good condition
of the automated system.
• The symbol
draws your attention to the notes on the characteristics and operation of the
product.
CE DECLARATION OF CONFORMITY
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi 32 - 24050 - Grassobbio - BERGAMO - ITALY
Declares that: Control board mod. BRAIN 06,
• conforms to the essential safety requirements of the following EEC directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Additional information:
This product underwent a test in a typical, uniform configuration.
(all products made by GENIUS S.p.A)
Grassobbio 01-09-2006. The Managing Director
D. Gianantoni
INDEX
1 WARNINGS ..............................................................................................................................................10
2 LAYOUT AND CONNECTIONS ...................................................................................................................10
3 TECHNICAL SPECIFICATIONS ...................................................................................................................11
3.1 DESCRIPTION OF COMPONENTS ................................................................................................................................................11
3.2 DESCRIPTION OF TERMINAL-BOARDS .........................................................................................................................................11
4 PROGRAMMING THE LOGIC .....................................................................................................................11
5 PROGRAMMING THE SPEED .....................................................................................................................11
6 START-UP ..................................................................................................................................................12
6.1 LEDS CHECK..............................................................................................................................................................................12
6.2 PROGRAMMING THE DIPS-SWITCH .............................................................................................................................................12
6.3 PRE-FLASHING ..........................................................................................................................................................................12
6.4 TIME - SETUP LEARNING .............................................................................................................................................................12
6.4.1 AUTOMATIC SET-UP .............................................................................................................................................................12
6.4.2 MANUAL SET-UP ..................................................................................................................................................................12
7 INSTALLATION OF BUS ACCESSORIES .......................................................................................................13
7.1 ADDRESSING THE BUS PHOTOCELLS ..........................................................................................................................................13
7.2 MEMORY STORAGE OF BUS ACCESSORIES ...............................................................................................................................14
8 MEMORY STORING THE RADIO CODE ......................................................................................................14
8.1 MEMORY STORAGE OF 868 RADIO CONTROLS .........................................................................................................................14
8.2 MEMORY STORAGE OF 433 RADIO CONTROLS .........................................................................................................................15
8.2.1 REMOTE MEMORY STORAGE OF 433 RADIO CONTROLS .....................................................................................................15
8.3 RADIO CONTROLS DELETION PROCEDURE ................................................................................................................................15
9 CONNECTION OF BUFFER BATTERIES (OPTIONAL) .....................................................................................15
10 AUTOMATED SYSTEM TEST ........................................................................................................................15
11 LOGIC TABLES ..........................................................................................................................................16