Genius DSC-1.3MTFT - 5-3 Loading and Removing the Memory Card; 5-4 Setting Up the OSD Language; 5-5 Date;Time

17
●Close and lock the battery cover.
NOTE:
Do not open the cover roughly to avoid damaging the battery
compartment cover.
If the battery power indicator shows only one black block that
means the power is wear, you can continue to use the flash.
When the battery indicator turns red, you cannot take still and
movie pictures any more.
5-3 Loading and Removing the Memory Card
●Make sure to turn off the camera.
1. Loading the memory card.
●Slide the switch on the battery cover in the direction indicated
by the arrow.
●Insert the memory card in the direction of the arrow.
2. Removing the memory card
18
●Press the memory card down gently.
●The memory card will bounce upward.
●Pull the memory card out with your fingers in the correct
direction.
NOTE:
Before using the camera, please remember to insert the
memory card into the slot. If the memory card is full or there
are already images stored in it, you can toggle the Mode Dial
to Setup Mode and then select "Format" item to
format the memory card. Please make sure you had backup
the important data stored in the memory card.
 There is 8MB internal memory built-in in the camera for
saving your data:
If there is a memory card inserted, it will be the top priority for
saving data.
If you want to store data in the internal memory, please
remove the memory card first.
●The specification of memory card applicable to this camera is
SD or MMC (4/8/16/32/64/128MB).
●If inserting the memory card in the wrong direction, it cannot
be fit in. Do not insert the card roughly to avoid damage.
●If the camera detects no memory card, please gently wipe the
metal interface of the card with a soft cloth and reloading the
card again.
5-4 Setting Up the OSD Language
Before using the camera, please turn the Mode Dial to Setup
Mode and then select "Language" to set the OSD
language. There are 3 options for your selection: English,
Traditional Chinese, and Japanese.
5-5. Date/Time
Before using the camera, please turn the Mode Dial to Setup
Mode and then select "Date/Time" to set the date and
time.