Cln:
This message
may
appear
on
the display.
If
it does,
your cassette tape player needs to
be
cleaned. It
will
still
play
tapes, but
you
should clean it as soon as possible
to
prevent damage to your tapes and player. See “Care
of
Your Cassette Tape Player”
in
the Index. After
you
clean
the player, press and hold EJECT for
five
seconds
to
reset the Cln indicator.
“---”
will appear
in
the display
to
show the indicator was reset.
Theft-Deterrent Feature
The theft-deterrent feature for the
A”
stereo with
cassette tape player can be used
or
ignored. If ignored,
the
system plays normally. If it is used, your system won’t be
usable
if
it’s ever stolen because it will go
into
LOC
mode
anytime your vehicle loses battery power. The unlock code
must be entered or the radio will not
turn
on.
Setting Your Security Code
The
following instructions will tell you how to enter a
security code
into
the system.
If
your vehicle
loses
battery power for any reason,
you
must enter the
security code again before the system will turn
on.
You
are now ready
to
enter your security code. Don’t
wait more
than
15
seconds between steps.
Press
4
SEEK
b
or
4
TUNE and
“0000”
will appear
on the display.
Press SEEK
4
and hold it until the first digit of your
code appears. Release the button.
Press
SEEK
b
and hold
it
until
the second digit
of
your
code appears. Release
the
button.
Press
TUNE
4
and hold
it
until the third digit
of
your
code appears. Release the button.
Press
TUNE
b
and hold
it
until the fourth digit
of
your
code appears. Release the button.
Press
AM-FM
after you have checked that the code you
entered
is
the one
you
wrote down. “rEP’ will appear
on
the display, which means
you
need
to
repeat steps
5
through
9.
Press
AM-FM
again and the display will now show
SEC.
Write down any four-digit number and keep it
in
a safe place.
Then
turn
the ignition switch
to
the ACC or
ON
position
and the audio system
off.
Press
the
1
and
4
buttons together.
Hold them down until
“----”
shows on the display.
3-10
To Next Page
Loading...
