Geonav 11C - Page 74

74
English
By using the joystick, choose the desired marker (the latest 8
markers used will be highlighted) from the catalog displayed,
then press ENTER to confirm.
Once the desired marker has been selected, the GEONAV will
insert a waypoint at the marker position and append the new
leg to the existing route (if no route is available, the new
waypoint will be connected to the boat’s position).
Press the EXIT key to go back to Navigation mode and enable
automatically the Autozoom function.
NOTE: To delete a single marker, select it from the GOTO Marker list and press the
CLR key.
FUNCTIONS IN THE MARKER MENU
Storing a set of markers in the CompactFlash™
Press the GOTO key to display the menu, select MARKER, CUR-
RENT, SAVE ALL and press ENTER. Use the joystick to change
the default name and press ENTER to confirm the operation.
A message will confirm that markers have been stored cor-
rectly. Once stored, markers will disappear from the screen.
Each time a set of markers is stored in the CompactFlash™,
the plotter memory is cleared and the indicator of the markers
available is reset to the maximum value.
Recalling a set of markers from the CompactFlash™
Press the GOTO key to display the menu, select MARKER, OLD
and press ENTER to open the marker catalog.
Select the marker set desired by using the joystick, then press
ENTER to confirm the operation, or EXIT to exit.
Deleting markers
To delete the set of markers displayed, press the GOTO key to
show the menu, select MARKER, CURRENT, DELETE ALL
and press ENTER to confirm.
Markers