90
English
Ethernet Connection
to be assigned network addresses different from those assigned
to any external device (PC, printer, server, etc.) connected to
the same network.
The setting of network parameters is automatic. To solve pos-
sible conflicts that cannot be handled automatically, this op-
eration can also be carried out manually. Press GOTO to display
the main menu, select SETUP, OTHER and then press the
GOTO and ENTER keys simultaneously.
Transferring the route
The operations that allow editing an active route - and that
are therefore transferable to all the instruments on the net-
work - are the following:
- Route editing (insertion, deletion and displacement of a
waypoint; recall and deletion of a route)
- Insertion of a waypoint and selection of the target waypoint
by the GOTO function
- Temporary editing of the route by the Easy Pilot function
(EBL knob)
As one of the above operations has been carried out from any
instrument connected to the network, switch from Cursor mode
to Navigation mode by pressing the EXIT key.
To Next Page
Loading...
Need help?
General
