252
18.5 Connecting the Camera
1
2
Figure 18-5
1. Use a standard network cable to connect the camera to your network.
2. Connect power using one of the following methods:
• plugging the power adapter to the power port. The power adapter
is an optional device. For detail, see Options in the manual.
• using the Power over Ethernet (PoE) function and the power will
be provided over the network cable.
3. When the ready LED of the camera shines green, the camera is ready
for use.
Note: PoE function is only supported for GV-CA120 and GV-CA220.
To Next Page
Loading...
Need help?
General