Born For FPV
Most of the time, the reason for a cross-over crash is that it is not checked before
takeoff. For the sake of safety, we suggest that you check before each flight. The steps
are as follows:
1. Turn on the transmitter and select the correct mode; Please confirm that the
unlocking switch is in the locked state and the throttle position is at the lowest
position;
2. Please check whether the appearance of the crossing machine is damaged. If there
is damage, please repair first, do not fly with damage；
3. Please confirm whether the propeller is installed correctly, and check whether the
propeller steering is correct. Please confirm whether the motor screw is tightened.
If it is not tightened, there is a risk of propeller shooting；
4. Check the battery voltage. In the fully charged state, 3S battery voltage should
be 12.6V, 4S battery voltage should be 16.8v, 6S battery voltage should be 25.2v;
5. Check whether the battery is firmly fixed on the aircraft by the strap, and whether
the battery line and balance head are fixed properly to avoid being cut down by the
propeller；
6. Observe the flight area to see if there is any safety risk, such as someone entering
the flight area, and observe the weather to judge whether there are flight
conditions；
7. Open the goggle or FPV screen to check if someone conflicts with your frequency.
If there is a conflict, never power your plane to avoid interfering with others
8. After connecting the battery, put the aircraft on the ground and do not move it until
three beeps are heard and the gyroscope is calibrated successfully；
9. Unlock and rotate before takeoff, observe whether the propeller will scratch the
antenna or power line, etc
10. Last step: Unlock flight
Add: if you choose to fly near the water source, please pay attention to safety. It's
difficult to salvage the crossing plane when it falls into the water, and the water in
the crossing plane is not covered by the warranty
To Next Page
Loading...
Need help?
General
