Born For FPV
Using transmitter recording function requires simple setting of camera and flight
control：
1. First, short circuit mode and GND of GoPro circuit board
2. Then connect the GoPro camera with the GoPro in-line interface of cinelog25.
3. Connect BetaFlight,Enter the following command in the command line cli:
resource LED_STRIP 1 NONE
resource PINIO 1 A08
set pinio_box = 40,255,255,255
save
4. In modes of BetaFlight turn on the USE1 mode,add Range,switch the SD third gear switch
on the transmitter,It will be mapped to aux4, and the range threshold will go to
the second segment,save
To Next Page
Loading...
