Need help?Do you have a question about the GEPRC MARK5 and is the answer not in the manual?
General| Frame Size | 5 inch |
|---|---|
| Wheelbase | 225mm |
| Arm Plate | 5mm carbon fiber |
| ESC | 45A BLHeli_32 |
| Flight Controller | GEPRC F722 FC |
| Camera | Caddx Ratel 2 |
| Battery | 6S LiPo recommended |
| Top Plate | 2.5mm carbon fiber |
| Bottom Plate | 2.5mm carbon fiber |
| FC Mounting | 30.5mm x 30.5mm |
| VTX Mounting | 20x20mm |
| Motor Mounting | 16x16mm |
| Camera Mounting | 19mm |
| Propeller | 5 inch |
| Receiver | PNP |
| Antenna | 5.8GHz |
Instructions for binding the DJI FPV Goggles and Transmitter to the quadcopter.
Details the binding steps involving the VISTA unit and its indicator lights.
Guides users through the Taranis transmitter menu for binding setup.
Steps to turn on the receiver while holding the bind button for pairing.
Instructions for setting up the Taranis transmitter for TBS Crossfire connectivity.
Steps for binding the TBS NanoRX receiver and initiating the update process.
Method to enter binding state by cycling the receiver power three times.
Steps to initiate binding from the Taranis transmitter's ELRS menu.
Provides the address to download and install the Betaflight configurator software.
Guides on checking AUX channels within the transmitter's MIXES menu and their assignments.
Instructions on entering and navigating the OSD menu using transmitter controls.
Provides a detailed table of VTX frequencies across different bands and channels.
Verifying transmitter mode and arming switch position before flight.
Performing a visual check of the quadcopter for any damage.
Confirming correct propeller direction and secure locking nuts to prevent dislodging.
Checking battery voltage and ensuring secure attachment to the aircraft.
To Next Page
