Gerber Technology AccuPlot AP-300 User Manual

Offline Operation
Initializing the Plotter 4-3
Initializing the PlotterInitializing the Plotter
You must initialize the plotter each time you apply power to the plotter and
after any emergency stop.
Initializing clears the plotter memory buffer and positions the pen assembly at
the origin (starting) position. Initializing also loads the operating parameters
currently defined for the plotter and moves the paper forward about 13 mm (½
inch).
TO INITIALIZE THE PLOTTER
1. From page one of the the Offline menu, press F2-INITIALIZE.
To stop initializing, press F3-STOP.
Putting the Plotter OnlinePutting the Plotter Online
Putting the plotter online links your marking and grading system to the plotter.
The plotter must be online to plot pieces and markers.
TO PUT THE PLOTTER ONLINE
1. Power on and initialize the plotter.
2. Press F1-ONLINE to put the plotter online. When the plotter is online,
press F3 to take it offline.
OFFLINE . . .
ONLINE PAPER ADV
INITIALIZE ORIGIN

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English