Offline Operation
4-26 Diagnostic Tests
NOTE: NOTE: After rebooting, the default parameters must be reloaded using the
Parameter Entry-Load Defaults (page 4-20) and saved using Save
Parameters (page 4-19).
After loading the default parameters, enter any parameters you recorded prior
to the download procedure, in order to return the plotter to your specific
settings.
Diagnostic TestsDiagnostic Tests
Diagnostic menu commands allow you test the operation capability of plotter
components. Most of these diagnostics are used primarily by service
personnel. There are three pages of Diagnostic menu.
• Page One diagnostics test plotting capability, control panel keys and the
control panel display.
• Page Two contains tests that can be performed only by qualified service
personnel.
• Page Three tests the pen and inkjet assemblies.
Figure 4-2 shows the structure of the complete plotter Diagnostics
menu.
To Next Page
Loading...
Need help?
General
