AccuPlot and AccuJet Maintenance
5-2 Routine Cleaning
Routine CleaningRoutine Cleaning
WARNING: FAILURE TO TURN OFF THE MAIN POWER SWITCH AND UNPLUG THE
PLOTTER POWER CORD FROM THE ELECTRICAL OUTLET BEFORE
BEGINNING ANY MAINTENANCE PROCEDURE COULD RESULT IN INJURY.
Daily — Inspect and clean the AccuJet inkjet cartridge using a cloth. Follow
the instructions beginning on page 5-15. Inspect and clean the AccuPlot pen
cartridge using the procedure on page 5-18.
Weekly — Clean the beam and linear bearing by wiping them with alcohol on
a lint-free cloth. Lubricate the linear bearing with oil applied on a rag.
Clean the interior of the rails on the left and right sides of the table surface by
first blowing compressed air beneath them and then wiping beneath them
with alcohol on a lint-free cloth.
As Needed — Clean painted portions of the plotter and table surface with a
mild soap solution. Clean unpainted surfaces of the plotter with alcohol on a
lint-free cloth.
To Next Page
Loading...
