Gerber Technology AccuPlot AP-300 User Manual

Power On and Initialization 2-1
The plotter must be online before it can accept and process data from your
marking and grading system. Before the plotter can be put online, power must
be applied and the plotter must be initialized.
The following are the procedures for starting, initializing, and putting the
plotter online. Read all the steps before beginning a procedure to be sure you
understand the process.
Power On and InitializationPower On and Initialization
The system must be initialized if power has been turned off or after an
Emergency Stop (E-Stop) is detected. Initializing clears the system’s memory
buffer and positions the head at the origin (starting) position.
NOTE: Before turning the system on, be sure the table surface and surrounding area
are clear of obstructions.
Power On
1. Be sure all plugs and connectors are in place and all safety features are in
place.
2. Switch the plotter main power to ON.
3. Turn the emergency stop switch in the direction of the arrows until it
unlocks and pops up. The plotter performs a self-test and then displays the
following system prompt:
Starting and Stopping the PlottersStarting and Stopping the Plotters
22
PLOTTER MODEL V X.X.X
Press enter to
enable the plotter.

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English