Offline Operation
Plotter Parameters 4-11
Plotter ParametersPlotter Parameters
The default operating parameter settings are designed to give you the best
performance and reliability over a wide range of applications. If necessary, the
Param Entry menu lets you change certain plotter operating characteristics to
match your plotting requirements.
You must use the Save Param function (page 4-19) to make changes
permanent. Otherwise, the plotter resets when you remove power and the
GGT default values are reloaded the next time you initialize the plotter.
Saved parameter settings remain as you set them even when the plotter is
powered off. You can also reload the GGT default parameters, if necessary.
Plotter operating parameters are grouped as follows:
Table
Used to adjust the table size and plot origin.
Plot
Control velocity and acceleration settings, the pen up
and pen down delay, and the pen timer.
Paper Adv
Set the amount of advance.
Servo
These parameters can be adjusted only by field
service personnel.
Inkjet
Control velocity and acceleration for the Inkjet
assembly.
Misc
These general settings apply to overall plotter
operation, including language, font, and character
set.
To Next Page
Loading...
Need help?
General
