Gerber Technology AccuPlot AP-300 User Manual

AccuPlot and AccuJet Maintenance
5-20 Plotter Pen Maintenance
TO INSTALL THE CARTRIDGE IN YOUR PLOTTER
WARNING: FAILURE TO DISABLE SERVO POWER BEFORE PUTTING YOUR HANDS IN
OR NEAR THE PLOTTING AREA COULD RESULT IN INJURY.
1. Insert the pen into the pen holder.
2. Insert the ink reservoir into the large round opening in the cover. Line up
the guide on the side of the ink reservoir with the notch in the large round
opening.
3. Hold the beam assembly to keep it from bending and press the reservoir
down firmly. This will secure the reservoir.
4. Turn the reservoir 90 degrees clockwise by one-quarter turn to lock the
reservoir in place.
5. Thread, by turning, the pen holder cap to the top of the pen holder.
Installation is complete.

Gerber Technology AccuPlot AP-300 Specifications

General

Brand	Gerber Technology
Model	AccuPlot AP-300
Category	Plotter
Language	English