________________________________________________
4
English
Energized Circuits
Ensure the power (voltage) cord is grounded and correctly connected.
Circuits must be de-energized before trained maintenance personnel
can safely work inside these areas. There must be a main switch to de-
energize each power supply that is compatible with local electrical
codes.
Do Not Operate in an Explosive Atmosphere
Use caution when handling flammable liquids such as cleaning solvents.
Do not operate equipment near flammable gases or fumes.
Moving Machinery
Keep hands away from all moving plotter parts to prevent personal
injury. Make sure no one else is near the plotter during operation.
Replacing Parts
Notify a Gerber Field Service Representative of any broken or missing
parts. Do not use parts or modifications that are not approved by Gerber
Technology. Equipment damage or personal injury could result.
Clothing
Do not wear loose clothing, neck chains, neckties, jewelry, or long hair
near the plotter. Failure to comply could result in personal injury.
Ink Cartridges
Refilling cartridges or using incompatible inks could result in equipment
damage. Use only approved ink cartridges from Gerber Technology.
Ink Hazards
If removed from the ink cartridge, the ink may cause the following:
• Contact with skin or eyes may cause irritation.
• Inhalation may cause drowsiness or dizziness.
• Ingestion may cause nausea, vomiting, and/or diarrhea.
To Next Page
Loading...
Need help?
General
