Gerber EDGE FX Installation Guide

1
Chapter 1:
Introduction
In this manual
This manual provides instructions on unpacking and connecting the GERBER EDGE FX™
printer. It also describes repacking procedures that you may need if you wish to ship the
equipment to a new location. Chapters are organized as follows:
Chapter 1: Introduction: provides information on how this manual is organized and how to get
help if you need it.
Chapter 2: Unpacking the GERBER EDGE FX: gives environmental and physical requirements,
verifies contents of the boxes, and details unpacking and connecting the printer.
Chapter 3: Connecting the GERBER EDGE FX to the computer: details how to connect the
GERBER EDGE FX to your computer through a network interface or through a direct
connection.
Chapter 4: Packing the GERBER EDGE FX: describes the repacking procedure in the event that
you need to ship the printer to another location.
Conventions
The following conventions are used in this addendum:
Tip: A tip contains valuable information that could make the task faster or easier.
Note: A note contains important information that could affect the successful completion of a
task.
CAUTION: A caution statement contains information which, if not observed, could
result in equipment damage.
WARNING: A warning statement contains information which, if not observed,
could result in personal injury.

Gerber EDGE FX Specifications

General

Print Technology	Thermal transfer
Resolution	300 dpi
Connectivity	Parallel
Media Types	Vinyl, Reflective
Max Media Width	15 in (381 mm)
Max Print Width	11.8 in (300 mm)