Gerber ODYSSEY XP - User Manual

Owner’s Guide

Summary

Chapter 1: Introduction

Safety

Provides essential safety warnings and precautions for operating the plotter.

Chapter 2: Getting Started

Unpacking and setting up the plotter

Instructions for unpacking and assembling the ODYSSEY XP plotter and stand.

Connecting the data and power cables

Guidance on connecting the plotter to a computer and power source.

Adding the ODYSSEY XP to the cutting software

Procedure for integrating the plotter with Gerber OMEGA or GA software.

Loading material

Detailed instructions on how to properly load various types of material into the plotter.

Installing tools

Steps for installing cutting tools, pens, or pounce tools into the plotter's tool holder.

Changing knife blades

Instructions on how to replace dull or damaged knife blades.

Adjusting knife blade exposure

Chapter 3: Running Jobs

Running jobs

Procedures for sending and executing cutting or plotting jobs.

Chapter 4: Tool Settings

Using the ODYSSEY XP with Gerber software

Controlling the plotter and its settings via Gerber OMEGA or GA software.

Choosing the material

Setting the tool force

Adjusting the downward pressure of the tool for optimal cutting and drawing.

Adjusting corners

Fine-tuning corner cutting accuracy for sharp and clean edges.

Setting the speed

Setting acceleration

Chapter 6: Troubleshooting

Warning messages

Error messages

Guide to interpreting and resolving system error codes displayed by the plotter.

Chapter 7: Maintenance

Cleaning

Grit wheels

Edge sensors

Cut strip replacement

Step-by-step guide for replacing the worn plotter cut strip.

AC fuse replacement

Instructions for safely replacing the plotter's AC power fuse.

Gerber ODYSSEY XP Specifications

General

Brand	Gerber
Model	ODYSSEY XP
Category	Printer
Language	English