Gerber ODYSSEY XP - Automatically Cutting off a Job

26
CHAPTER 3
Running Jobs
To pause a job and restart a job
1
To pause a job, press F1, Pause-Job.
2
The current Job Status changes to Paused. To restart the job, press F1,
Start-Job.
The plotter returns to the previous position and resumes running.
After all jobs have completed, the plotter returns to
No Job
status.
To cancel a job
1
To cancel a job, press CANCEL. The
JOB CANCELED
message appears
briefly, then the plotter stops and returns to the MAIN MENU.
Multiple jobs in the spooler are cleared one at a time by pressing
CANCEL.
2
After you cancel a job, reposition the tool before beginning the next
job.
Automatically cutting off a job
After you complete a job, you can have the plotter cut it off.
To have the plotter perform auto cutoff correctly, the following
conditions must be met:
♦
You cannot do an auto cutoff during a job.
♦
Auto cutoff cuts 1/2" (1.2 cm) beyond the pinch wheel centers.
Material past the 1/2" (1.2 cm) will not be cut.
♦
The knife blade must be installed and have enough exposure to cut
through the material. The knife used for cutting a job is also used for
auto cutoff.
F1
MAIN MENU
Pause-Job Settings
Mode: Single
Job Status: Runnin
g
MAIN MENU
Start-Job Settings
Mode: Single
Job Status: Paused
F1