42
CHAPTER 5
Advanced Functions
Chapter 5:
Advanced Functions
Previous chapters presented information on basic ODYSSEY XP plotter
operations such as loading material, installing tools, running a job, and
choosing tool settings. This chapter provides information about
additional ODYSSEY XP functions including:
♦
repeats
♦
material pulldown
♦
pouncing
♦
factory default settings
♦
communications
CAUTION: You should not attempt these procedures unless you are
very sure you understand exactly what you are changing and the
effects it will have on the operation of your plotter.
To use advanced functions, go to the Operational Setup menu.
♦
From the Main Menu, hold down the ENTER key and press F3.
Repeats
Repeats allows you to reproduce the job you have just plotted up to 9999
times. You must run a job first in order to repeat it. Jobs larger than
14MB cannot be repeated. Do not repeat cut-to-print jobs.
The difference between doing repeats in Single and Multi mode is:
♦
Single - The plotter stops after each repeat. You can change materials
or reposition the starting point before the next repeat.
♦
Multi - The plotter runs all the repeats without stopping.
To Next Page
Loading...
