Gerber ODYSSEY XP - Chapter 6: Troubleshooting

48
CHAPTER 5
Advanced Functions
Turning off pounce
Pounce remains in effect until it is turned off. Turning the plotter off and
back on does NOT turn off pounce. Follow the procedure below to turn
off pouncing before sending a cut or plot job to the plotter.
Tip: Use a piece of vinyl carrier to store the pounce strip and keep it clean for
future re-use.
To turn off pounce
1
Press F3 while holding down the ENTER key.
2
Press F4, Misc. to get the Misc Settings menu.
3
Press F3, Pounce to get the Select Pounce Type screen.
4
Press F3 or F4 until the pounce setting reads
OFF
.
5
Press Enter twice to return to the Main Menu.
6
Remove the pounce tool.
7
Remove the pounce cut strip.
8
Reset tool force to its previous value.
Factory default settings
There are three levels of factory default settings that can be restored on
the ODYSSEY XP:
♦
the default settings for the current material
♦
the default settings for all materials
♦
the defaults for all settings