WIFI network will be on the 192.168.10.0/24 network with Airconsole set as
192.168.10.1/24 and enabled as a DHCP server).
Note for firmware 1.x that after a factory reset the SSID will always be AirConsole-XX
rather than AirConsole-A3 or what is printed on the back of the unit. You can change it to
match the SSID printed on the back of the unit via the built in webpage.
8.2.2 Factory Reset procedure for version 2.x Firmware
With the unit powered on, insert a paperclip to press the reset button, keep it pressed for
3 seconds and then release the button. On release of the button the Airconsole LED will
change to solid blue for a few seconds then the Airconsole will reboot (Red LED,
followed by slow blue blinking, followed by blue intermittent blinking)
For Wifi access: SSID=Airconsole-XX (where XX is as printed on the back of the
Airconsole), password 12345678
For Web console: Admin username and password are "admin"
WIFI network will be on the 192.168.10.0/24 network with Airconsole set as
192.168.10.1/24 and enabled as a DHCP server).
Note for firmware 2.x and later after a factory reset the SSID should remain the same
9 Upgrading Airconsole Firmware
Airconsole Firmware can be upgraded via the Admin -> Firmware Page.
Download the latest Firmware and Firmware upgrade instructions from the www.get-
console.com/airconsole webpage. The firmware instructions and firmware downloads
are on the right hand side of the page under Airconsole Resources.
To Next Page
Loading...