3.4 OPERATION DESCRIPTION
Screen Reader
Screen shows “S” : means “ Manual Operation”
Screen shows “ ErO” means “ Emerge Stop”
Screen shows “ Er1” means “ Film Breaking”
Screen shows “A” means “ Program A”
Screen shows “B” means “ Program B”
Screen shows “C” means “ Program C”
PROGRAM BUTTONS A, B & C
These buttons are for programs setting and selections:
Program A. This button is already pre-program to run the machine with
spiral up and spiral down wrapping cycle.
Program B This buttons are pre-program for spiral up and spiral down.
The first stage is for Spiral up, then the machine will pin punch the film
and stopped.
The second stage is for spiral down and the machine will pin punch the
film and stopped. But, before the machine start to run, the operator must
press the green button to start.
Program C This button is for spiral up, after the machine pin punch the
film, the elevator will return back to the starting position.
WRAP CNT. ( TOP & BOTTOM) BUTTON, REINFORCEMENT
Press this button to select the number of top wrapping count from 0 to 9
first, then set up the bottom wrapping count from 0 to 9 as well.
To Next Page
Loading...
