GETINGE-LA CALHENE ISOTEST | User manual
NTA
3015/78 C
Approuvé informatiquement / Electronic signature
DEX | Page 11/
5. SAFETY INFORMATION
DANGER
Do not use the ISOCYT isolator in an explosive atmosphere.
Only use "HYDROCYDE" hydrogen peroxide with a concentration
of 35 % as recommended by Getinge-La Calhène
WARNING
The ISOCYT isolator makes use of hazardous toxic products. The
user must take all necessary steps before the proper authorities to
have this new equipment included in their safety analysis study.
The technicians who will use these machines must have previously
undergone a specific adapted training process.
When handling hydrogen peroxide, please consult the product
toxicity sheet (see appendix).
It is compulsory to wear gloves and goggles when handling
hydrogen peroxide.
Only persons who have been trained in using the ISOCYT isolator
are authorised to perform biodecontamination cycles.
In the event of a leak of hydrogen peroxide in liquid or gaseous
form during a biodecontamination cycle, the operators must
press the "EMERGENCY AERATION" button twice in less than
8 seconds and evacuate the hazard area.
An emergency / evacuation procedure must be in place for this
purpose.
During the biodecontamination phase, the isolators must be
connected to an extractor linked directly to the outside of a building
to allow aeration.
Make sure that the extractors, generally located on the roof, are
protected against rain and high winds and sufficiently separated
from passage areas and other heating, ventilation and A/C air
intakes.
The isolator pipes may only be removed after carrying out after the
auxiliary isolator aeration phase, taking all necessary precautions in
order to compensate for the risk of residual H
2
O
2
in the pipes.
To Next Page
Loading...
Need help?
General