GFI System SKYLAB REVERB User Manual

ON/OFF LED PRESET LED
Orange: Preset A, Green : Preset B
4
User Manual
TEMPO LED
Momentary Operation
< when bypassed > ~ Holding the Engage/Ramp button down for at least 1/2 sec triggers mo-
mentary operation, i.e pedal will revert to bypassed state when footswitch is released.
Ramping
< when engaged > ~ Holding the button for at least 1/2 sec triggers ramping operation : a
mapped parameters is ramped from its initial value to pre-configured final value, and stays at
that final value for as long as the footswitch is held down. When switch is released the parame-
ter gradually returns to its initial value.
A/B - TAP switch Priority.
Priority for the AB/TAP footswitch can be reversed in Global setting (see page 6 for details).
A/B - TAP SWITCH
TAP
-> bypass / engage
HOLD (when bypassed) for > 500 ms
-> engages momentarily
HOLD (when engaged) for > 500 ms
-> start parameter ramping.
TAP
-> change preset (A <-> B)
HOLD for 1 second
-> enter tap-tempo mode: when
tempo LED stops blinking you may tap
in the new tempo*.
* Tap-tempo is applicable only in
Tremble mode.
SKYLAR
REVERB
ENGAGE / RAMP SWITCH
6. Footswitches and LEDs

GFI System SKYLAB REVERB Specifications

General

Brand	GFI System
Model	SKYLAB REVERB
Category	Music Pedal
Language	English