Installation steps
To install the battery cover: B
Warning: Make sure edge of the battery cover is well placed before installing
your RIDESENSE. Otherwise, the battery cover may fail to seal closely, the battery
compartment spring may fail, or the waterproof function may get lost. (Please refer to
installation steps given earlier.)
To install RIDESENSE: C
Remove the bike included seat stay plug (not included with standalone
RIDESENSE product), insert the RIDESENSE antenna in the seat stay tube,
attach and fasten the RIDESENSE device to the seat stay with one SHCS using a
2.5mm hex wrench at maximum locking torque of 0.4Nm.
Note: Please make sure the battery cover is well sealed for 100% waterproof.
Warning: Make sure the RIDESENSE is well locked before each and every bike ride
or you may suffer function failure or even severe personal injury.
To Next Page
Loading...
