- 20 -
GA-8INXP Motherboard
English
1
IDE4
1
1
IDE1IDE2
8) IDE1 / IDE2 [IDE1 / IDE2 Connector (Primary/Secondary)]
Important Notice:
Please connect first hard disk to IDE1 and
connect CD-ROM to IDE2.
The red stripe of the ribbon cable must be the
same side with the Pin1.
9) IDE3 / IDE4 (RAID/ATA133, Green Connector)
Important Notice:
The red stripe of the ribbon cable must be the
same side with the Pin1.
If you wish to use IDE3 and IDE4, please use
it in unity with BIOS (either RAID or ATA133).
Then, install the correct driver to have proper
operation. For details, please refer to the RAID
manual.
1
IDE3
10) S_ATA1/S_ATA2 (Serial ATA Connector)
You can connect the Serial ATA device to this
connector, it provides you high speed transfer
rates (150MB/sec).
1
7
GND
TXP
TXN
GND
GND
RXP
RXN
To Next Page
Loading...
