- 21 -
Hardware Installation Process
English
13) PWR_LED
MPD+
MPD-
MPD-
1
PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
(Blue) Pin 2: LED cathode(-)
SPK (Speaker Connector) Pin 1: VCC(+)
(Amber) Pin 2- Pin 3: NC
Pin 4: Data(-)
RES (Reset Switch) Open: Normal Operation
(Green) Close: Reset Hardware System
PW (Soft Power Connector) Open: Normal Operation
(Red) Close: Power On/Off
MSG(Message LED/Power/Sleep LED) Pin 1: LED anode(+)
(Yellow) Pin 2: LED cathode(-)
NC (Purple) NC
14) F_PANEL (2x10 Pins Connector)
NC
HD+
MSG+
2
20
1
19
PW-
PW+
RES-
SPK-
1
1
RES+
HD-
MSG-
1
SPK+
1
1
11) RAM_LED
Do not remove memory modules while RAM
LED is on. It might cause short or other unex-
pected damages due to the 2.5V stand by
voltage. Remove memory modules only when
AC Power cord is disconnected.
+-
12) 2X_DET
When an AGP 2X (3.3V) card is installed the
2X_DET will light up, indicating a non-supported
graphics card is inserted. Informing users that
system might not boot up normally due to AGP
2X (3.3V) is not supported by the chipset.
+-
To Next Page
Loading...
