Gigabyte GA-E7AUM-DS2H - Page 11

Hardware Installation- 11 -
Internal Connectors  1 x 24-pin ATX main power connector
 1 x 4-pin ATX 12V power connector
 1 x floppy disk drive connector
 1 x IDE connector
 5 x SATA 3Gb/s connectors
 1 x CPU fan header
 1 x system fan header
 1 x front panel header
 1 x front panel audio header
 1 x CD In connector
 1 x S/PDIF In/Out header
 3 x USB 2.0/1.1 headers
 1 x IEEE 1394a header
 1 x parallel port header
 1 x serial port header
 1 x chassis intrusion header
 1 x power LED header
Back Panel  1 x PS/2 keyboard or PS/2 mouse port
Connectors  1 x D-Sub port
 1 x DVI-D port
(Note 2)
 1 x HDMI port
(Note 3)
 1 x optical S/PDIF Out connector
 1 x IEEE 1394a port
 1 x eSATA 3Gb/s port
 6 x USB 2.0/1.1 ports
 1 x RJ-45 port
 6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side
Speaker Out/Line In/Line Out/Microphone)
I/O Controller  iTE IT8718 chip
Hardware Monitor  System voltage detection
 CPU/System temperature detection
 CPU/System fan speed detection
 CPU overheating warning
 CPU/System fan fail warning
 CPU/System fan speed control
(Note 7)