Gigabyte GA-E7AUM-DS2H - Integrated Peripherals

GA-E7AUM-DS2H Motherboard - 48 -
2-6 Integrated Peripherals
Onboard IDE Channel
Enables or disables the integrated IDE controller. (Default: Enabled)
NV SATA Controller
Enables or disables the integrated SATA controller. (Default: Enabled)
OnChip SATA Mode
Configures the operating mode of the integrated SATA controller.
IDE Configures the SATA controller to IDE mode. (Default) (Only for the SATA2_0~2 connectors)
RAID Enables RAID for the SATA controller.
AHCI Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
On-Chip USB
Configures the integrated USB controller.
V1.1+V2.0 Enables the integrated USB 1.1 and USB 2.0 controllers. (Default)
V1.1 Enables only the integrated USB 1.1 controller.
Disabled Disables the integrated USB 1.1 and USB 2.0 controllers.
USB Keyboard Support
Allows USB keyboard to be used in MS-DOS. (Default: Disabled)
USB Mouse Support
Allows USB mouse to be used in MS-DOS. (Default: Disabled)
Legacy USB storage detect
Determines whether to detect USB storage devices, including USB flash drives and USB hard
drives during the POST. (Default: Enabled)
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Integrated Peripherals
Onboard IDE Channel [Enabled]
NV SATA Controller [Enabled]
Onchip SATA Mode [IDE]
On-Chip USB [V1.1+V2.0]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
Legacy USB storage detect [Enabled]
Onboard Audio Function [Auto]
HDMI Audio [Auto]
Onboard 1394 [Enabled]
On-Chip MAC Lan [Auto]
 SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level