GA-E7AUM-DS2H Motherboard - 78 -
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Ensure NV SATA Controller is enabled under Integrated Peripherals. To create RAID, set Onchip
SATA Mode to RAID (Figure 1). If you do not want to create RAID, set this item to IDE or AHCI.
Figure 1
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Integrated Peripherals
Onboard IDE Channel [Enabled]
NV SATA Controller [Enabled]
Onchip SATA Mode [RAID]
On-Chip USB [V1.1+V2.0]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
Legacy USB storage detect [Enabled]
Onboard Audio Function [Auto]
HDMI Audio [Auto]
Onboard 1394 [Enabled]
On-Chip MAC Lan [Auto]
SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
To Next Page
Loading...
