Appendix- 83 -
Copying the SATA RAID/AHCI driver from the motherboard driver disk to a USB flash drive
Step 1:
On an alternative system, copy the SATA RAID/AHCI driver to your USB flash drive from the motherboard
driver disk. For example, to install the Windows Vista 32-bit operating system
(Note)
on the NVIDIA
GeForce 9400 SATA controller, copy the N7ARV32 file (Figure 4) located in the BootDrv folder in the
motherboard driver disk to your USB flash drive.
Step 2:
Double-click the N7ARV32 file in the USB flash drive. When a screen similar to that in Figure 5 appears,
type "yes" after the "Continue extraction?" message, and then press <Enter> to begin extracting the
driver. After the driver is extracted, a screen similar to that in Figure 6 will appear.
(Note) In RAID mode, copy the N7ARV32 file for Windows Vista 32-bit operating system
or N7ARV64
for Windows Vista 64-bit.
In AHCI mode, copy the N7ASV32 file for Windows Vista 32-bit operating system
or N7ASV64
for Windows Vista 64-bit.
Figure 4
Figure 5
Figure 6
To Next Page
Loading...
