Gigabyte GA-X79-UP4 - Trusted Computing

- 51 -
BIOS Setup
& XHCI Hand-off
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support.(Default:Enabled)
& EHCI Hand-off
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support.(Default:Disabled)
& Port 60/64 Emulation
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default:Disabled)
& USB Storage Devices
Displays a list of connected USB mass storage devices. This item appears only when a USB storage device
is installed.
` Trusted Computing
& TPM SUPPORT
 EnablesordisablesTrustedPlatformModule(TPM).SetthisitemtoEnable when a TPM device is installed.
(Default:Disable)
& Fresco USB3.0 Controller#1 (Fresco FL1009 USB 3.0 Controller, USB 3.0/2.0 ports routed
to the onboard F_USB30 header)
 EnablesordisablestheFrescoFL1009USB3.0controllers.(Default:Enabled)
& Fresco USB3.0 Controller#2 (Fresco FL1009 USB 3.0 Controller, USB 3.0/2.0 ports on
the back panel)
 EnablesordisablestheFrescoFL1009USB3.0controllers.(Default:Enabled)
` SuperIOConguration
 ThissectionprovidesinformationonthesuperI/Ochipandallowsyoutoconguretheserialport.
& Serial Port A
 Enablesordisablestheonboardserialport.(Default:Enabled)