Gigabyte GA-X79-UP4 - Page 78

Appendix
- 78 -
Delete the RAID Array:
To deleted the existing array, press <Enter> on the RAID tab and select Delete VD. When the Delete VD menu
appears, press <Enter> on the array to select it and then press <Enter> on NEXT. When prompted, press <Y> to
conrm(Figure10). When the message "Do you want to delete the VD's MBR?" appears, press <Y> to clear
the MBR or press other keys to ignore.
Figure 10
Use the Marvell Storage Utility in the Operating System:
With the Marvell Storage utility, you can set up an array or view the current array status in the operating system.
To install the utility, insert the motherboard driver disk, then go to Application Software\Install Application
Software and select Marvell Storage Utility to install. Note: After the installation, you must login the utility with
the same account name and password that you use to login the operating system. If you did not set the account
password before, click Login to enter the Marvell Storage Utility directly. Please note that if you set the hard
drive(s)toIDEorAHCImode,itisnormalthatyouwillnotseetheharddrive(s)intheMarvellStorageUtility.
[ Adapter] [ Devices]
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
[ RAID ]
Delete the VD?[Y]
RAID Cong
ID Name Size Level Status Stripe CacheMode
* 0 GBT 152.4GB RAID0 ONLINE 64KB WriteBack
NEXT
Delete VD