Gigabyte GA-X79-UP4 - Page 81

- 81 -
Appendix
Refer to the following for installing the driver during the Windows setup process.
Step 1:
Restart your system to boot from the Windows XP setup disk and press <F6> as soon as you see the message
"Press F6 if you need to install a 3rd party SCSI or RAID driver." A screen will then appear asking you to specify
an additional SCSI adapter. Press <S>.
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.
Step 2:
InserttheoppydiskcontainingtheSATARAID/AHCIdriverandpress<Enter>.Selecteitherthe32-bitor
64-bititemsdependingonwhetheryouwanttoinstallthe32-bitor64-bitversionofWindowsXP(Figure4).
Both of the Marvell shared library and Marvell 91xx SATA Controller need to be installed. Below we assume
that you are installing the 32-bit version. First select Marvellsharedlibraryfor32bit(installrst) and press
<Enter>. On the next screen, press <S> to return to the screen in Figure 4. Then select Marvell 91xx SATA
Controller 32bit Driverandpress<Enter>.Whenbothofthetwodriversappearontheconrmationscreen,
press <Enter> to continue the driver installation.
Figure 4
Windows Setup
You have chosen to congure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Marvell shared library for 32bit (install rst)
Marvell 91xx SATA Controller 32bit Driver
Marvell shared library for 64bit (install rst)
Marvell 91xx SATA Controller 64bit Driver