BIOS Setup
- 143 -
2-11 BIOS POST Beep code (AMI standard)
2-11-1 PEI Beep Codes
# of Beeps Description
1
Memory not Installed.
1
Memory was installed twice (InstallPeiMemory routine in PEI Core called
twice)
2
Recovery started
3 DXEIPL was not found
3 DXE Core Firmware Volume was not found
4 Recovery failed
4
S3 Resume failed
7
Reset PPI is not available
2-11-2 DXE Beep Codes
# of Beeps Description
1 Invalid password
4 Some of the Architectural Protocols are not available
5 No Console Output Devices are found
5 No Console Input Devices are found
6 Flash update is failed
7 Reset protocol is not available
8 Platform PCI resource requirements cannot be met
To Previous Page
Loading...
Need help?
General
