Gigabyte R181-2A0 - Replacing the Power Supply

System Hardware Installation - 36 -
3-9 Replacing the Power Supply
Follow these instructions to replace the power supply:
1. Press the retaining clip on the right side of the power supply along the direction of the arrow.
2. Pull up the power supply handle at the same time and pull out the power supply.
3. Insert thereplacementpowersupply rmlyintothe chassis.ConnecttheACpowercord to the
replacement power supply.
1
2
3
Before you remove or install the system cover
• MakesurethesystemisnotturnedonorconnectedtoACpower.