Gigabyte R182-Z90 - Removing Chassis Cover

System Hardware Installation - 27 -
3-1 Removing Chassis Cover
Before you remove or install the system cover
• MakesurethesystemisnotturnedonorconnectedtoACpower.
Follow these instructions to remove the chassis cover:
1. Remove the screw securing the chassis cover.
2. Loosenthethumbscrewsecuringthechassiscover.
3. Push down the indentations located on the sides of the chassis cover.
4. Slide the cover cover to the rear of the system and then remove the cover in the direction indicated
by the arrow.
5. To reinstall the chassis cover reverse steps 1-4.
2
3
3
1
4