Gigabyte R182-Z90 - R182-Z90

- 40 - System Hardware Installation
3-8-2 R182-Z91 / R182-Z92
ReadthefollowingguidelinesbeforeyoubegintoinstalltheHarddiskdrive:
• Takenoteofthedrivetrayorientationbeforeslidingitout.
• Thetraywillnottbackintothebayifinsertedincorrectly.
• MakesurethattheHDDisconnectedtotheHDDconnectoronthebackplane.
Follow these instructions to install a 2.5" hard disk drive:
1. Press the release button.
2. Extend the locking lever.
3. Pullthelockingleverinthedirectionindicatedtoremovethe2.5"HDDtray.
4. Orienttheharddiskdrivesotheopeningontherearoftheharddiskdriveisalignedtothe
positioningstudontheHDDtray.
5. SlidetheharddiskdriveintotheHDDtray.
6. ReinserttheHDDtrayintotheslotandclosethelockinglever.
Press
Pull
1
2
3
5
4